Installing The Spoils Auger; Product Overview; Specifications - Toro TXL 2000 Operator's Manual

4

Installing the Spoils Auger

No Parts Required
Procedure
Before operating the trencher, install and position the
spoils auger to work correctly with the digging chain
configuration you are using. If you do not position the
spoils auger correctly, you could damage the trencher.
1. Use the bolt and nut removed from the auger
previously to secure it in the correct holes, as
shown in Figure
1. Connect these holes for a
10 cm (4 inch) chain.
2. Connect these holes for a
15 cm (6 inch) chain.
2. Torque the bolt to 183 to 223 N∙m (135 to 165
ft-lb).
6.
Figure 6
3. Connect these holes for a
20 cm (8 inch) chain.
4. Connect these holes for a
30 cm (12 inch) chain.

Product Overview

Specifications

Note:
Specifications and design are subject to
change without notice.
With 91 cm
(36 inch)
boom
Dig depth at 91 cm
60 degree
(36 inches)
boom angle
150 cm
Width
(59 inches)
66 cm
Height
(26 inches)
178 cm
Length
(70 inches)
Approximate 515 kg
weight with
(1,135 lb)
chain
Note:
Wider chains will increase the weight of the
trencher.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
g270649
8
With 122 With 152
cm (48 inch) cm (60 inch)
boom boom
122 cm 152 cm
(48 inches) (60 inches)
150 cm 150 cm
(59 inches) (59 inches)
66 cm 66 cm
(26 inches) (26 inches)
216 cm 244 cm
(85 inches) (96 inches)
554 kg 583 kg
(1,220 lb) (1,285 lb)