Product Overview; Specifications; Operation; Installing And Removing The Attachment - Toro 22550 Operator's Manual

Product Overview

1. Attachment plate

Specifications

Note:
Specifications and design are subject to
change without notice.
Overall width
Overall depth
Overall height
Bolt-on edge
Approximate Weight
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
Figure 3
2. Leveler frame
185 cm (73 inches)
127 cm (50 inches)
58 cm (23 inches)
1.6 x 15.2 cm (5/8 x 6 inches)
386 kg (850 lb)

Operation

Determine the left and right sides of the machine from
the normal operating position.
Installing and Removing
the Attachment
Refer to the Operator's Manual for the traction unit for
the installation and removal procedure.
g272256
Important:
Before installing the attachment,
position the machine on a level surface, ensure
that the mount plates are free of any dirt or debris,
and ensure that the pins rotate freely. If the pins
do not rotate freely, grease them.
Note:
Always use the traction unit to lift and move
the attachment.
WARNING
If you do not fully seat the quick-attach
pins through the attachment mount plate,
the attachment could fall off the machine,
crushing you or bystanders.
Ensure that the quick-attach pins are fully
seated in the attachment mount plate.

Leveling the Ground

When leveling the ground, angle the leveler slightly
to keep the forward edge higher than the rear edge.
Therefore, when driving the traction unit forward, the
edge farthest from the traction unit should be higher;
when driving in reverse, the edge closest to the
traction unit should be higher.
5