Installing The Digging Chain; Installing The Crumber - Toro TXL 2000 Operator's Manual

2

Installing the Digging Chain

Parts needed for this procedure:
1 Digging chain (sold separately)
Procedure
1. Remove the bolt and locknut securing the spoils
auger and remove the auger
Note:
Retain the hardware for installation later.
1. Bolt (5/8 x 4 inches)
2. Spoils auger
2. Refer to Installing the Digging Chain (page 16)
to install the chain.
(Figure 4).
Figure 4
3. Locknut (5/8 inch)
3

Installing the Crumber

Parts needed for this procedure:
1 Crumber (provided with boom)
Procedure
Install the crumber using the 4 bolts (1/2 x 1-3/4
inches), 4 flat washers, 4 spring washers, and 4 nuts
(1/2 inch) as shown in
Note:
Ensure that there is at least 5 cm (2 inches)
between the chain and crumber plate.
g270627
1. Nut—1/2 inch (4)
2. Flat washer (4)
3. Spring washer (4)
7
Figure 5.
Figure 5
4. Crumber
5. Crumber plate
6. Bolt—1/2 x 1-3/4 inches
(4)
g270626