Electrolux EKC6046 User Manual page 16

16 electrolux
Stainless Steel cream cleaners are abrasive
and should be avoided as they may dull the
surface finish.
Any spillage on the stainless steel finish must
be wiped off immediately.
Warning! Do not attempt to remove any
of the control knobs from the appliance
as this may cause damage and is a
safety hazard.
Cleaning the control knobs and handles
It is strongly recommended that only hot
soapy water is used for cleaning the control
knobs and handles.
ANY OTHER CLEANING MATERIALS MAY
DULL THE SURFACE FINISH.
Removing and replacing the wire work
runners
1. Remove all shelves
and furniture from
the oven.
2. Hold the wire work at
the bottom, unclip
from the cavity side
and gently pull to-
wards the centre of
the oven.
3. Unhook the runner
at the top and re-
move from the cavi-
ty.
4. To replace the run-
ners, hook the wire
work side runner into
the cavity, slide back
and press into place.
Warning! Ensure
the wirework runners are firmly in
position before replacing the oven
shelves.
Cleaning the ceramic hob
Make sure the ceramic glass is cool before
cleaning.
It is important to clean the ceramic hob daily
to prevent soilage being burnt on.
Important! Take care to avoid the hob trims
when cleaning the ceramic glass as they may
be damaged by the cleaning agents
recommended.
Daily cleaning
Use the recommended hob cleaner daily.
If soilage is not allowed to burn on it will be
much easier to clean off.
1. Apply a small amount of hob cleaner in
the centre of each area to be cleaned.
2. Dampen a clean paper towel or a plastic
pad made specially for non-stick sauce-
pans and rub vigorously until all marks are
removed. This may take a few minutes.
3. Wipe off residues of cleaner with another
damp paper towel and polish dry with a
soft cloth.
If hob cleaner is unavailable, one or more of
the cleaning agents below may be used
temporarily:
a) Cream Cleaner
b) Baking Soda
To remove stubborn marks
1. An abrasive cream cleaner may be used
to clean off more stubborn stains or to
remove discolourations. It may be nec-
essary to rub the marks hard for several
minutes.
2. Use a plastic pad specially for non-stick
saucepans with an abrasive cream clean-
er for removal of more stubborn soilage.
To remove burnt on soilage
We strongly recommend the use of a Ce-
ramic Hob Scraper (incorporating a single
edge razor blade) to remove spillage on the
hob, in particular sugar solutions, which if not
removed can cause permanent damage.
1. Make sure the ceramic glass is cool.
2. Use a ceramic hob scraper with care at
an angle of 30° to remove as much soi-
lage as possible.
3. Use an abrasive cream cleaner or hob
cleaner to finish off as directed above.
To remove discolouration or white and
silver marks
These marks sometimes give the impression
of being in or underneath the hob glass.
They can almost always be removed provi-
ded they have not become excessively burnt
on.
Follow the instructions above under 'To Re-
move more Stubborn Marks'.
If this is unsuccessful, make up a paste of
one part water to three parts Cream of Tarter