Yamaha QY70 Owner's Manual page 27

T h e
y [EXIT] Key
No matter where you are in the QY70 display hierarchy, the
[EXIT] key will take to the next highest level (effectively "backing
up" one step — unless you're already at the top display).
u Cursor Keys
These 4 keys move the "cursor" around the display
screen, highlighting the various parameters that are available for
editing (the QY70 cursor appears as a dark block with inverse
characters).
TRY THIS:
Select the SONG mode display (use the [SONG] key, as
described above), then try using the cursor keys to move
the cursor around the screen.
i [-1/NO] and [+1/YES] Keys
These keys are used to edit (change the value of) the
parameter at which the cursor is currently located. The [-1/NO]
key decrements (decreases stepwise) the value of the selected
parameter, while the [+1/YES] key increments (increases
stepwise) the parameter. Press either key briefly to decrement or
increment the parameter by one, or hold the key for continous
decrementing of incrememnting in the specified direction.
The [-1/NO] and [+1/YES] keys are also used to respond to
"Are you sure?" prompts when they appear. Press [+1/YES] to
go ahead with the operation, or [-1/NO] to cancel.
NOTE
• For even faster decrementing or incrementing, press the opposite
increment/decrement key while holding the key corresponding to the
direction you want to increment/decrement in.
TRY THIS:
Select the SONG mode display (use the [SONG] key, as
described above), use the cursor keys to select the trans-
pose parameter ("TRNS" on the display), then try using the
[-1/NO] and [+1/YES] keys to change its value. Set it back
to "+00" before continuing.
C o n t r o l s



 
3
25