Yamaha QY70 Owner's Manual page 121

The "M" parameters below the lower graphic bar specifiy the
destination measure:beat to which the data will be copied, as well as the
number of times the data is to be copied.
The "Transpose" parameter sets a transpose value for the copied
data in semitone increments from "-24" through "+00" to "+24".
The Chord template parameter, above the upper graphic bar, appears
only when the "Cd" track is selected at the "TR" parameter. This param-
eter specifies which chord progression, either the user chord progression
programmed in the source "Cd" track or preset chord template, will be
copied to the User chord progression.
After setting the parameters as required press [ENTER] to execute
the Copy Event job. The metronome icon will appear on the display while
the data is being processed, then "Completed" will appear briefly when
the job is done. Press the [EXIT] key to return to the job list, or a mode key
to go directly to the selected mode.
NOTE
• Previous data in measures overwritten by the Copy Event job will be completely
erased and replaced by the copied data.
• The time signature is copied by the Copy Event job, but Voice and Play Effect data
is not copied.
• The Copy Event job makes it easy to use phrases or even complete sections (an
entire chorus, for example) in more than one place in a song. You can copy a phrase
played by one voice, and have it repeated by a different voice later in the song. You
can always edit the copied sections to create variations.
T h e S o n g
Destination measure.
Destination beat.
J o b s
Number of times to be copied.



 
9
119