Table of Contents
Advertisement
4. Receiving the product
The individual components of the mixer or flowmaker are packed
carefully from the factory to prevent any damage to the surface
protection during transportation.
Make sure that the mixer or flowmaker cannot roll or
fall over.
Before attempting to lift or otherwise handle the
individual components of the mixer or flowmaker,
observe any local regulations that set limits for the
weight of components to be lifted manually by
individuals, i.e. handled without the use of lifting
equipment.
All lifting equipment must be rated for the purpose
and checked for damage before attempting to lift the
components. The lifting equipment rating must under
no circumstances be exceeded.
4.1 Inspecting the product
On delivery, check the mixer or flowmaker and any accessories
supplied with it for transport damage. This also applies when the
equipment is delivered to the installation site.
Do not install a damaged mixer or flowmaker.
If the mixer, flowmaker or any accessories have been damaged,
contact your local Grundfos company before installing the
product. Do not unpack a damaged new component for further
inspection, unless instructed by your local Grundfos company.
Dispose of packaging material according to local regulations.
6
5. Installing the product
During installation, only lift the mixer or flowmaker using the
suspension point. See figs
1
and 2.
Do not use the lifting equipment supplied with the mixer or
flowmaker as well as the wire used for lifting and lowering the
mixer or flowmaker into the tank as universal lifting equipment.
Never hang the mixer or flowmaker by the power
cable.
Never let the mixer or flowmaker run while
suspended from the lifting equipment.
Fig. 1
Mounting of lifting wire on motor bracket
Fig. 2
Mounting of lifting wire on SMD
Use the lifting equipment supplied with the product
only for lifting the mixer or flowmaker.
See pages
31-33
for details about weights.
Advertisement
Table of Contents
