SOMFY ZDMI Manual

Z-wave digital motor interface

Table of Contents

Download this manual

DESCRIPTION

The Somfy Z-Wave Digital Motor Interface (ZDMI) is a Z-Wave routing device

that resides as a node within a designated Z-Wave control network. It receives

Z-Wave transmissions and converts them to motor control commands for Somfy's

Sonesse 50 ILT2 (AC) motor and Sonesse 30 RS485 (DC) motor. The interface

also receives feedback information from these motors and distributes it to the

Z-Wave network.

Typical Sonesse 30 RS485 Motor Connection

•

The Sonesse 30 Motor configuration is powered externally by +24VDC. Using the Power Cable

(part no. 9016020) make sure that the white wire is on the left, and the black wire is on the right

when plugged into the interface. Apply +24 VDC to the white wire, and -24 VDC to the black wire. -

•

The interface must be mounted within thirty (30) feet of each motor head and attached by a

Com cable to its respective modular communication port.

ZDMI INTERFACE

Part No: 1870171

Typical Sonesse 50 ILT2 Motor Connection

www.AVOutlet.com

+24 VDC

24 VDC

Table of Contents

Do you have a question about the ZDMI and is the answer not in the manual?

Page 1 ZDMI INTERFACE DESCRIPTION The Somfy Z-Wave Digital Motor Interface (ZDMI) is a Z-Wave routing device that resides as a node within a designated Z-Wave control network. It receives Z-Wave transmissions and converts them to motor control commands for Somfy’s Sonesse 50 ILT2 (AC) motor and Sonesse 30 RS485 (DC) motor. The interface also receives feedback information from these motors and distributes it to the Z-Wave network.
Page 2 NETWORK SETUP In order for the ZDMI to become fully operational, all connections must be properly made according to the wiring diagram, and the electronic limits of the motor must first be set. Please refer to the respective motor instructions on how to set the electronic limits.
Page 3 SETUP button, and the INCLUSION LED begins to blink slowly then rapidly after 5 seconds. 3. Upon rapid blinking of the LED, release the SETUP button. The LED will remain off. ZDMI ELECTRICAL SPECIFICATIONS Voltage Input: Requires Regulated +24VDC. Voltage Output: Regulated +24 VDC, passed through from the Input Voltage Power Consumption: 50 mA @ 24VDC.
Page 4 Power Cable (supplied) 9016020 Com Cable (supplied) 9016021 Somfy Technical Support USA CONTACT SOMFY 800-647-6639 Monday through Friday 8:00AM – 8:00PM EST Somfy Customer Service Email USA North East Region CSRNE@somfy.com Southeast Region CSRSE@somfy.com Central Regions CSRNE@somfy.com West Coast Region CSRWC@somfy.com...

Hwg800