SOMFY ZigBee Quick Start Manual

®
ZigBee to Digital Motor Interface (ZBDMI)

DESCRIPTION

®
The Somfy ZigBee to Digital Motor Interface (ZBDMI) is
a ZigBee routing device that resides as an endpoint
within a designated ZigBee control network. It
receives ZigBee transmissions and converts them
to motor control commands for Somfy's line of ILT2
(AC) motors, and the Sonesse 30 RS485 (DC) motor.
The interface also receives feedback information
from these motors and distributes it to the ZigBee
network.

WIRING DIAGRAMS

Typical Sonesse 30 RS485 Motor Connection
5063281G01 Sonesse 30 RS485
Node ID: 06:00 1E
2Nm 24VDC
28 rpm 0.8A IP 30
Made in USA
SOMFY 74300-France
24V DC in
From Power Supply
* Included with ZigBee to ILT2 Interface
Note: For Sonesse 30 RS485 motors revision H and higher,
the adaptor cable must be used as shown above.

GENERAL REQUIREMENTS

When installing the ZBDMI with a Sonesse 30 RS485 motor, apply +24V DC to the white wire
and -24V DC to the black wire.
When installing the ZBDMI with a Sonesse 50 ILT2 motor, the interface is powerd by the ILT Com
cable once the motor is connected to 120V AC.
The interface must be mounted within thirty (30) feet of each motor head and attached by a Com
cable to its respective modular communication port.
Sonesse 30 RS485 revision H and higher have a modified RS485 data port that requires the RS485
adaptor cable (part no. 9019192) included with the ZBDMI.
One interface is used for each Somfy Sonesse 50 ILT2 and Sonesse 30 RS485 motor.
Adaptor
Cable
*
RS485 Com Cable
*
24V DC to motor
24 VDC IN
24 VDC OUT
ILT2 COM
RS 485 COM
SETUP
INCLUSION
Typical ILT2 Motor Connection
®
ZigBee to Digital Motor Interface
1870220
ILT Com Cable
+24 VDC
-24 VDC