Advertisement
F
IRES OF
Step #11
Secure the leg into position by slipping
the black rubber plug (supplied) through
the slot in the bracket, into the lug on the
side of the leg.
Wipe any excess cement from the joints
where it may have squeezed out.
Important: Make sure you do not step
on the hearth, as this will leave marks,
and will possibly cause it to lose level!
Step #13
T
I
I
RADITION
NSTALL
P
S
NSTRUCTIONS FOR
OLANO
Now that the inner slip system is in
place the leg can now be cemented in
place.
Note; One person will need to steady
the vertical and horizontal of the four
piece slip system while the leg is
removed until the leg is replaced again.
Carefully remove one leg and apply a
thin bead of cement along the edges
where it comes into contact with the
hearth, vertical slip piece, horizontal slip
piece, wall, and secondary riser. Replace
the leg and repeat for the other leg
making sure both are firmly bedded.
Step #12
Check the fit of the shelf onto the top
of the beam and bracket, then remove.
Adjust bracket if necessary. Apply a
thin bead of cement along the top edge
of the legs, against the back edges of
the shelf, and along the inside edge
where the shelf comes into contact with
the horizontal piece from the slip sys-
tem. Carefully lower the shelf into
position onto the beam. Use a small
wood shim in the joint between the
beam and legs if necessary to insure
that the top surface of the shelf is level.
9
11
AGE
OF
M
#4012
ANTEL
Advertisement
