Advertisement
F
IRES OF
Step #11
Now that the inner slip system is in
place the leg can now be cemented in
place.
Note; One person will need to steady
the vertical and horizontal slips while the
leg is removed until the leg is replaced
again.
Carefully remove one leg and apply a
thin bead of cement along the edges
where it comes into contact with the
hearth, vertical slip piece, horizontal slip
piece, and wall. Replace the leg and re-
peat for the other leg, making sure both
are firmly bedded.
Step #13
T
I
I
RADITION
NSTALL
P
S
NSTRUCTIONS FOR
OLANO
By carefully and gently tilting the leg
to the side, you can now set the arched
upper slip onto position onto the side
slips already in position. This step is a
two person job. Make sure that when the
leg is tilted that it is tilted on the side and
not on the tip of the corner where the
side meets the front, as this may cause
chipping. Insure that there is an even gap
between the edge of the outer frame on
the Clearview and the inside of the
Jurastone slips.
Step #12
Secure the leg into position by slipping
the black rubber plug (supplied) through
the slot in the bracket, into the lug on the
side of the leg. Bracket and rubber plug
are shown in position.
Wipe any excess cement from the joints
where it may have squeezed out.
Important: Make sure you do not step
on the hearth, as this will leave marks,
and will possibly cause it to lose level!
15
11
AGE
OF
M
#4012
ANTEL
Advertisement
