Advertisement
F
IRES OF
Step #6
With a pencil, make a mark on both
sides
where
the
positioned on the wall.
Remove the leg and secure the brackets
to the wall, using the wall plugs supplied,
making sure that the slot in the bracket
will be located over the hole in the leg
that the rubber plug [supplied] will slide
into.
T
I
I
RADITION
NSTALL
bracket
cleat
Step #8
P
S
NSTRUCTIONS FOR
OLANO
The front plate of the Fenderfire can be
adjusted
inwards
loosening the 4 screws on the inside of
the frame. Insure that this plate lies flush
with the notched face of the base of the
4pc frame (this step may need to be
repeated after the install is complete).
Carefully set each leg into position on
the hearth, positioning the inside of the
leg up against the "stop" created by the
cutout in the lower riser.There is a light
line marked on the hearth indicating the
approximate position of the foot of each
leg.
Step #7
is
Note: the legs aren't secured yet, so there
is a very high risk for one to fall over and
be damaged. Exercise extreme caution
while working around them. At no point
during this step should the legs be
cemented to any other part of the mantel.
Carefully lower the vertical pieces of the
four piece slip into place. Note the places
on the bottom of the slip where the slip
comes into contact with the bottom riser.
Remove the vertical pieces and apply a
small bead of cement to the base of the
four piece slip system, and replace the
verticals.
7
11
AGE
OF
M
#4012
ANTEL
and
outwards
by
Advertisement
