Advertisement
F
IRES OF
Step #3
Carefully slide the hearth into position,
centering it on the fireplace (draw a very
small center line on the top back edge of
the hearth to easily locate). Put a couple
of small pencil marks on the floor
indicating its final position, then remove
the hearth.
Mix up a small bit of the grout/cement
by adding a small amount of water until
you get a paste like consistency. Butter
the bottom of the hearth with a thin bead
of the cement provided, and reset the
hearth into position. Insure that the
hearth is level. A couple of wood shims
[not supplied for this purpose] carefully
positioned under the hearth can help
keep it level while the cement dries.
Make sure that the any shims used are
removed and the holes touched-up.
T
I
I
RADITION
NSTALL
Step #5
P
S
NSTRUCTIONS FOR
OLANO
The wooden 2x3 backing for the steel
bracket must be installed according to
the dimensions shown. Insure that this
framing is centered on the fireplace and
the wall, as this will dictate the final
position of the mantel.
It is crucial that the horizontal piece of
2x3 span the entire 39 3/8" and be
installed level. Locate the wall studs and
secure this horizontal 2x3 to these with
the appropriate length screws at the cor-
rect distance from the floor.
The mid hearth can now be set into
place and centered on the hearth.
A small pencil line on either side of the
risers will allow you to easily find the
right place once you have removed and
applied the cement.
12
11
AGE
OF
M
#4012
ANTEL
Step #4
Advertisement
