Restore Factory Defaults - Pliant Crewcom 2400 Operating Manual

Restore Factory Defaults

Users can choose to restore factory defaults for the device or system. When restoring factory defaults, these settings
are reset to their original factory settings:
1. Press and hold the RP Menu button for 2 seconds; then, use the far-right volume knob to scroll and select Tech
Menu . Press F2 ( ENT ).
2. Scroll and select Factory Defaults press F2 ( ENT ) to enter view reset options.
3. Scroll and select Restore Defaults or Clear Memory and press F2 ( ENT ).
4. Confirm your selection by selecting either Yes or No .
The table below lists the settings that are affected when restoring RP factory defaults or clearing RP memory.
Note: Clearing an RP's memory erases the RP pairing information from the device. The pairing is still
visible in the CCF, but since the RP has no Profile assignment, you must re-pairing the RP to begin
using it again.
Radio Pack Factory Settings
Radio Pack Setting
Pack Name (Long)
Pack Name (Short)
Battery Alert
Contrast
Backlight Brightness
Backlight Time Out
Mic Type
Mic Gain (Dynamic)
Mic Gain (Electret)
Noise Gate
Sidetone
Minimum Volume (all knobs) 0 (off)
Radio Pack Default Reset by "Restore Defaults" Reset by "Clear Memory"
ESN#
ESN#
Both
7
High
30 seconds
Auto Detect
6 (+23 dB)
3 (-4 dB)
Low (-75 dB)
Med (-12 dB)
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Operation - 50