Call - Pliant Crewcom 2400 Operating Manual

Call

Call signals may be initiated by entities across CrewNet. Each 2-Wire intercom port may be individually set to send
and receive a CrewCom-generated call signal to or from a connected wired intercom system by enabling the Call
function for that port. Disabling the Call function for that port prevents the signal from leaving CrewCom via the
respective port.
Call: An RP Function button option. When enabled for wireless devices, the user can elect to send a call signal
l
to the RPs of each conference whose Talk button is currently active on that individual RP, or the user can elect
to send a call signal to the RPs of a single assigned conference (regardless of the associated Talk button's
status). When enabled for external hardwired intercom devices, a signal will be sent to any connected 2-wire
devices associated with a conference whose Talk button is currently active on that individual RP (as long as
outbound call is enabled for the CU port associated to the conference) or a signal will be sent to any connected
2-wire devices associated with that conference (as long as outbound call is enabled for the associated CU
port). Call can be enabled for both wireless and hardwired devices or limited to only one type.
Call on Talk: An RP Talk button function. When enabled, a call signal will remain active while the Talk button
l
is active. This function is commonly used in applications where a two-way radio interface is connected.
In addition to enabling Call for the CU port(s), you will need to set up Call on the Radio Pack Profile. This is best done
via CrewWare; refer to the CrewWare Manual for more information on this process.
Operation - 46