Stereo Input Cue/Solo Switch: Pre-Fader Or Follow Mt Pre Switch - Yamaha PM4000 Operating Manual

6.5 Stereo Input Cue/Solo Switch: Pre-
Fader or Follow MT PRE Switch
As shipped from the factory, the stereo channel CUE/
SOLO switch applies signal to the left and right cue
busses from a point which is derived just ahead of the
channel fader (actually, just ahead of the fader-con-
trolled VCA). However, an internal jumper in each
stereo input module enables this function to be altered
Figure 6-5. Internal Switch Positions For Cue/Solo being Pre-Fader
or tracking the METER PRE Switch on Stereo Input Module,
and Corresponding Block Diagram Location.
so that the take-off point for the cue/solo signal tracks
the signal feed to the channel's LED level meter. In this
way, the cue/solo feed will be post-fader (or post-VCA to
be more exact) until the METER PRE switch is set to
Pre mode; then it will be pre-fader. The channel's CUE
output has true stereo left and right components,
derived from the discrete stereo input. The switch
positions are illustrated below in Figure 6-5.
Page 6-6