Stereo Master To Matrix St Bus: Pre Or Post - Yamaha PM4000 Operating Manual

6.15 Stereo Master to Matrix ST Bus:
Pre or Post ST Master Fader
A slide switch in Stereo Master module enables the
signal applied to the matrix stereo bus from that
module to be derived from two different points. As
shipped, the switch is preset so the matrix is fed its
Figure 6-15. Internal Switch Positions For Pre- and Post- Stereo Master Fader Feeds to Mix Matrix,
signal after the Stereo Master fader [58] so that adjust-
ments in the stereo output also affect the feed to the
matrix. The internal switch can be repositioned so that
the matrix is fed pre Stereo Master fader. In this way,
the stereo output can be used for one feed, and it can be
remixed in the matrix to create other stereo feeds.
and Block Diagram Location.
Page 6-16