Table of Contents
Advertisement
6.6 Mono & Stereo Input Channel MT
PRE Switch: Pre- or Post-ON Switch
Two jumpers in each mono input module (four on
each stereo input module) permit the channel level
meter's MT PRE switch function to be altered. As
shipped, when the channel is set so that the meter is in
Figure 6-6. Internal Jumper Positions For MT PRE switch Post function Being Post Fader and Channel
ON switch or Post Fader and Pre Channel ON switch, and Corresponding Block Diagram Location.
POST mode, the meter indicates the level after the
Fader and the channel ON switch. By chaning the
jumpers as indicated, the POST function can be made to
show the level after the Fader, but before the channel
ON switch. This is useful for checking and adjusting the
level even though the channel output is muted via a
Master Mute function or the channel on/off switch.
Page 6-7
Hide quick links:
Advertisement
Table of Contents
