Assembly Procedure - ABB Power2 800-M Assembly Instructions Manual

Assembly Instructions / Power2 850-M
4 Installing the low-pressure stage / 4.2 Assembly procedure
4.2

Assembly procedure

Attach lifting gear to the two suspension points of the bearing casing.
u
Check that the orifices specified for the low-pressure stage have been installed in both oil
u
supply pipes.
Check that the gaskets have been correctly fitted at the oil inlet and the oil outlet in the
u
bracket.
Align the low-pressure stage on the engine.
u
Tighten the fixing elements on the foot
u
Secure all gas, air, water and oil pipes.
u
Attach cable connector to the speed sensor.
u
© Copyright 2019 ABB. All rights reserved.
(see Table 8: Fixing element requirements
HZTL455311P0010_EN
→11).
Revision A March 2019