Yamaha DME Setup Manual page 8

4 Master ID
When a device is assigned as a Slave in Master/Slave (2) above, this sets the host address for the Master device in that
group. This parameter cannot be set for the Master device.
5 Link Mode
Make sure that "100Base-TX" is selected.
10
If the system includes multiple DME devices, repeat the above settings for each individual device.
Refer to the DME manual for information on audio connection and further network connection details.
n
If you will be using CobraNet™ for audio connections, the required bundle numbers and related settings must be made via the DME
Designer application.
n
If you will be using EtherSound™ for audio connections, the routing and other EtherSound settings must be made via the AuviTran AVS-
ESMonitor software available from the AuviTran website:
http://www.auvitran.com/view.php?products_AVS-ESMonitor.php
Directly Connecting a Single DME Device to a Computer
When only one DME device is to be controlled, connect the device to the computer via a USB cable as described
in "DME Network Setup" on
Connecting Multiple DME Devices to a Computer in the Same Subnet
Connect multiple DME devices to the computer via a switching hub and Ethernet cables.
Device Group
DME Satellite
(IP Address: 192.168.0.3)
(Master ID: 2)
n
It is possible to connect the computer to the Device Group Master using a USB cable.It is also possible to connect the computer to a
Slave DME using a USB cable if a DME Satellite is assigned as the Device Group Master.
n
Use a switching hub that is capable of 100Base-TX operation.
n
The maximum length of cables that can be used to connect DME units to a switching hub is 100 meters. Proper operation at this length,
however, will depend on the quality of the hub and cables used, and cannot be guaranteed.
n
Use CAT5 STP (shielded twisted pair) type cable to maximize resistance to electromagnetic interference.
DME Setup Manual
Computer to DME Connection
page 6.
USB cable
Group Master
DME Satellite (IP Address: 192.168.0.2)
Ethernet cable
Switching hub
Ethernet cable
DME64N/24N
(IP Address: 192.168.0.250)
(Master ID: 2)
Ethernet straight cable
Ethernet straight cable
Computer
(IP Address: 192.168.0.100)
8