Rear Vent
NOTICE: Once appliance is set up for top or rear venting,
it CANNOT be changed at a later time.
Figure 6.7
•
Fold the tabs toward the center of the fire plug (90º)
and remove the insulation gasket.
Figure 6.8
•
Cut the metal retaining band and fold the sides out.
Heatilator • NDV30-IFT, NDV33-IFT, NDV36-IFT, NDV36-IFT-NVR, NDV42-IFT Installation Manual • 2620-980 Rev. C • 8/20
Figure 6.9
•
Fold the center parts of the retaining band out and use
to remove the vent cap.
NOTICE: Once the vent cap has been removed it CANNOT
be reattached.
Figure 6.10
•
Discard the vent cap, remove and discard the insulation
basket.
Figure 6.11
•
Attach the first vent section (it will snap into place). Slide
the insulation gasket onto the vent section, up against
the appliance and over the tabs.
37