Keyboard Stand Assembly - Yamaha Clavinova CLP-265GP Owner's Manual

Keyboard Stand Assembly

Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to
install all parts in the correct orientation. Please
assemble in accordance with the sequence given
below.
• Assembly should be carried out by at least two per-
sons.
• Be sure to use the correct screw size, as indicated
below. Use of incorrect screws can damage the
stand.
• Be sure to tighten all screws upon completing the
assembly of each unit.
• To disassemble, reverse the assembly sequence
given below.
Have a Phillips-head (+) screwdriver ready.
1.
Remove all parts from the box. Confirm
that all parts shown in the illustration are
included.
Main unit
Legs
AC power cord
52
CLP-265GP Owner's Manual
Lean the unit against the
wall as shown at right.
6 × 40 mm fixing screws
Pedal box
6 × 20 mm fixing screws
Cord holder
How to position the main unit
CAUTION
• Be careful not to pinch your fingers.
Be sure to position the keyboard side on the bottom.
Spread a large soft cloth, such as a blanket, on the floor.
Place the unit on the cloth with the key cover closed and
the keyboard side on the bottom and lean the unit
against the wall so that the unit will not fall or slip. Place
a soft cloth against the wall to protect the instrument and
the wall from scratches.
CAUTION
• Do not place the main unit
with the rear side facing
down.
CAUTION
• Do not lay the main unit
upside down on the floor.
CAUTION
× 12
• Do not position the main
unit so that its bottom is in
contact with floor.
× 4