Gigaset N870 IP Pro Site Planning And Measurement Manual page 48

Working with the Gigaset N720 SPK PRO
Changing the settings for metering mode
In the service menu, you can change the unit of measure and the measurement interval for
metering mode.
RSSI measurement
Metering Mode:
<dBm
Metering range:
06
Back
RSSI measurement
Metering Mode:
dBm
Metering range:
< 06
Back
§Start§
Press the display key to activate metering mode.
§Back§
Press the display key to exit the service menu again.
The handset is deactivated. When you reactivate it, it is in metering mode with the selected settings.
You should not make changes to other settings in the service menu.
48
Metering Mode (unit of measure)
On the display, the signal strength (RSSI value) is shown in dBm
as standard. You can also display the signal strength as a per-
centage value. This represents the signal strength of the pack-
>
age received as a ratio of the maximum possible RSSI (100%).
r
Use the navigation key to select the desired display
of the signal strength.
dBm: The signal strength measured is displayed in dBm.
This is preset and is the recommended mode.
%: The signal strength measured is displayed
as a percentage of the maximum possible RSSI
Change SEN: Not relevant.
Metering range (measurement interval)
The measurement interval defines the time intervals at which
measurements are taken.
Value range: 06 – 16 (1.0 s – 2.5 s)
Recommended value: 16
r
Use the navigation key to select the required
>
measurement interval.
Start