Gigaset N870 IP Pro Site Planning And Measurement Manual page 25

Positioning the base stations in the plan
Now enter the base stations.
HS
•
The example shows five base stations.
•
One base station is used to show how, by drawing in transmission directions for the wireless
signal, you can estimate how many base stations can see each other and which building
areas the wireless signal could reach.
•
For the hotspot in the room at the top left, two additional base stations have been planned
in parallel.
•
If full wireless coverage is required for the stairwell, measurements must be performed
to check whether a further base station has to be located here.
•
You must also check whether the base stations planned are sufficient for the second hotspot.
You then check these initial assumptions later using the measurements (
WC/
store
Stairs
Projecting the DECT network
Computer
HS
¢
P. 26).
25