Yamaha DIGITAL MIXING STUDIO 01X Owner's Manual page 28

Overview of the 01X
Input channel
● Input channels 1 through 8
These are monaural input channels used mainly for input
of microphones or line-level instruments. The signals that
are input to input channels 1 through 8 pass through an
attenuator, phase switch, 4-band EQ, and dynamics proces-
sor, and are sent to the stereo bus, AUX buses 1 through 4
and Rec bus. Input channels 1 through 8 also have a direct
output (DIRECT OUT), which allows them to be sent
directly from mLAN outputs.
● Input channels 9 through 24 (mL1 through mL16)
These are input channels for the signal from mLAN IN.
Each of these channels is structured the same as the input
channels. When the 01X is set to 88.2kHz (Macintosh
only)/96kHz operation, mLAN input (from computer to
the 01X) is limited to 8 channels (9-16: mL1-mL8).
• Faders and most parameters of adjacent odd-even channels are
linked for stereo operation (page 102).
INPUT 1(...8)
INSERT
ATT 4BAND EQ
NAMICS
METER
(Gain Reduction)
Mono in X 8
*1 *2
INPUT 9(...24 ) (mL1-mL16 )
INSERT
mLAN IN 4BAND EQ
ATT
NAMICS
*2
1-16
METER
(Gain Reduction)
Mono in X 16
(96kHz/88.2kHz: X 8)
mLAN INPUT
16 *2
mLAN IN
IEEE 1394
2
mLAN STEREO IN
(MONITOR IN)
(to MONITOR CASCADE)
28
01X Owner's Manual
METER
ON LEVEL
PAN
DY-
PRE/POST ON AUX
*3
DIRECT
OUT1(...8)
METER
ON
LEVEL
PAN
DY-
AUX
PRE/POST ON
*3
DIRECT
*1
OUT9(...24 )
*1 Wordclock 96kHz/88.2kHz : 16
*2 Wordclock 96kHz/88.2kHz : 8
*3 Studio Manager only
● 01X Channel Module
The included "01X Channel Module" is a special plug-in
effect that reproduces the Dynamics and four-band EQ
processing of these input channels using the process-
ing power of your computer (refer to the separate Instal-
lation Guide). You can use the 01X Channel Module on
your DAW independently from the 01X. For example
when recording, you can apply Dynamics and EQ to the
01X's monitor sound only and record dry to the DAW,
then play back the track, processing it with the 01X
Channel Module as needed — all without the 01X.
(Refer to the "DIRECT OUT POSITION" on page 91
and the 01X Channel Module PDF manual.)