the synchronized external device? ...................................................... page 92, "Settings by mLAN Auto Connector" (Installation Guide)

• Is the master device operating in a stable way?

• Is an effect such as HQ.Pitch or Dual Pitch selected?..................................................................................................................... page 102

■ The layer of 17-24 (mLAN9-16) cannot be used.

• When the sampling rate is set to 96kHz/88.2kHz, the layer of 17 – 24 (mLAN) can not be selected.............................................. page 40

■ Cannot edit with Studio Manager.

• Has the STUDIO MANAGER ID been set correctly? ...................................................................................................................... page 94

• Is Port 4 (Studio Manager) selected for Studio Manager data transmission/reception? ............... Studio Manager Owner's Manual (PDF)

■ The Remote Control or Automation features do not work.

• Is the correct DAW software selected in Remote Select? ................................................................................................................. page 87

• Are the mLAN settings correct?........................................................................................................................................Installation Guide

• Are settings on the DAW correct? ...................................................................................................................... page 67, Installation Guide

• Is Port 1 selected for mLAN MIDI transmission/reception?.............................................................................. page 67, Installation Guide

■ Cannot change the wordclock.

• Set this with the mLAN Auto Connector when using mLAN........................... "Settings by mLAN Auto Connector" (Installation Guide)

• Is the mLAN Auto Wordclock (AUTO W.CLK) setting appropriate? .............................................................................................. page 92

■ Cannot install the driver.

• Is the mLAN cable properly connected? Check the connection; disconnect the mLAN cable once, then insert it again.

■ The mLAN connection does not work.

• Has the driver been installed?............................................................................................................................................Installation Guide

• Is the mLAN cable properly connected? Check the connection; disconnect the mLAN cable once, then insert it again.

• (For Windows) Is mLAN set to "ON"? From the taskbar, right click on the mLAN Manager icon. ..............................Installation Guide

• (For Windows) When adding a new IEEE 1394 card, right click on the

mLAN Manager icon in the taskbar and select "ON.". .....................................................................................................Installation Guide

• Is the ACTIVE lamp on the rear panel of the 01X lit (in blue)? If it is not lit, check the followings:

• In mLAN Driver Setup (from taskbar, right click on the mLAN Manager icon,

then "Driver Setup"), is the Status indicator blue? If not, restart the 01X and

re-enable connection by using mLAN Auto Connector. ...................................................................................................Installation Guide

• Is mLAN AUTO W.CLK (Auto Wordclock) on the 01X set to "ENABLE"?................................................................................... page 92

• Has connection been enabled with mLAN Auto Connector?

Re-enable connection if necessary..................................................................... "Settings by mLAN Auto Connector" (Installation Guide)

• Have you changed the device? Even if the model is the same,

if the actual device is different, it is necessary to re-enable

connection by using Auto Connector................................................................. "Settings by mLAN Auto Connector" (Installation Guide)

• Is there a loop connection? Check the cabling and make sure none of the devices are connected in a loop.

Example of loop connection

Computer

01X

: IEEE 1394-equipped device

Troubleshooting

147

01X Owner's Manual

Table of Contents