Other Precautions - Panasonic SC-HG1-C User Manual

4-15 Other precautions

• For the HG-T series controllers, waveform values will be temporarily reset during measurement if
the following commands are written.
Command code
0x001E
0x0046
0x0047
0x0048
0x0059
0x0300
0x0304
0x0305
0x0306
0x030C
0x030D
0x031E
0x0325
• For the HG-T series controllers, approximately five seconds after the power is turned ON, measured
values are synchronously collected from the heads connected to each controller.
WUME-SCHG1C-4
Name
BANK LOAD execution (LOAD)
Average count (SPEED)
Measurement direction (DIRECT)
Alarm delay count (DELAY)
Sampling cycle (SAMPLI)
Operation mode (OP.MODE)
Sensitivity setting
Judgment level (JDG.LVL)
Judgment filter (JDG.FIL)
Stain check (STA.CHK)
Stain threshold (STA.THR)
Sensor head cumulative run time (HD.TIME)
Reverse insertion check (DIR.CHK)
CC-LINK Network Communication
Remarks
―
―
―
For write only
For write only
For write only
For write only
For write only
For write only
For write only
For write only
―
For write only
4-71