How To Use The Built-In Timer; Timer Play - Yamaha AV-1 Owner's Manual

HOW TO USE THE BUILT-IN TIMER

TIMER PLAY

MEMORY AUTO/MAN'L PRESET/BAND DISPLAY
VIDEO 2
TIME ADJ TIMER
/ /
REPEAT
HOUR MIN
OPEN/CLOSE
PONENT SYSTEM AV–1
2
2-
TUNER
CD
CENTER/REAR
/DELAY
C/R/D
ON/OFF DSP
TEST
SLEEP
POWER AMP
TRACK PRESET
PRO LOGIC DSP OFF
ENHANCED MONO MOVIE
ROCK CONCERT VIDEO
DISCO HALL STADIUM
/
CD TUNER TAPE/MD VCR
2-
PRESET
LEVEL
PROGRAM
SUBWOOFER
2-
INPUT
VOLUME
By using the built-in timer, you can set the time when
this system turns on and a source begins playing
automatically, and the time when this system turns into
the standby mode automatically.
1
Prepare the source to be played.
For tuner:
Tune in to the station you will listen to.
For CD player:
Load a disc on the disc tray.
2
Press the DISPLAY button.
Whenever the DISPLAY button is pressed, the
display mode changes as follows.
On each mode, make a setting for the timer play,
following the setting procedure described below.
Current time (TIMER on/off mode)
Source selecting mode (TUNER, CD)
ON TIME/Time setting mode
OFF TIME/Time setting mode
Normal display mode
Note
The display mode will be changed to the next
mode after about 8 seconds elapse in turn
automatically. If the mode is changed before the
setting is completed, call the mode again by
pressing the DISPLAY button once or more.
Setting procedure:
Current time
Check to be sure that the current time is correct,
and press the TIMER button so that "TIMER"
lights up on the display.
Source selecting mode
Select the source (TUNER or CD) to be played
by pressing the corresponding input selector
button.
* If "TUNER" is selected, soon it is changed to
the frequency display mode. In this mode, you
can select the station to listen to by the timer
play by using the PRESET/BAND button and
/ button.
E-49