Adjustments Before Listening Operations; Setting The Clock; Adjusting Brightness Of The Display - Yamaha AV-1 Owner's Manual

ADJUSTMENTS BEFORE LISTENING OPERATIONS

SETTING THE CLOCK

1
MEMORY AUTO/MAN'L PRESET/BAND DISPLAY
TIME ADJ TIMER
/ / REPEAT
HOUR MIN
2
MEMORY AUTO/MAN'L PRESET/BAND DISPLAY
TIME ADJ TIMER
/ /
REPEAT
HOUR MIN
RDS MODE RDS START FREQ PS/PTY/RT/CT
3
MEMORY AUTO/MAN'L PRESET/BAND DISPLAY
TIME ADJ TIMER
/ /
REPEAT
HOUR MIN
RDS MODE RDS START FREQ PS/PTY/RT/CT

ADJUSTING BRIGHTNESS OF THE DISPLAY

If desired, you can adjust brightness of the display.
1
Press and hold the DISPLAY button for more than 2
seconds so that "DIMMER±0" appears on the
display.
2
Holding the DISPLAY button pressed, press the
" / " button once or more to increase or press
the " / " button once or more to decrease
brightness.
Changes
Changes
E-25
1
While the power is on, press the DISPLAY button to
display the time. If this system is in the standby
mode, you can proceed to the next step.
2
While holding the TIME ADJ button pressed, press
the HOUR button and set the hour.
* Press the HOUR button once to advance the time
by 1 hour. Press and hold to advance
continuously.
3
While holding the TIME ADJ button pressed, press
the MIN button and set the minute.
* Press the MIN button once to advance the time by
1 minute. Press and hold to advance
continuously.
* The hour setting will not advance even if minute is
advanced from "59" to "00".
Europe, U.K., Australia and Singapore models use
a 24-hour display. U.S.A. and Canada models use
a 12-hour display shown by "AM (PM) 12:00". For
General model, either the 24-hour display or the
12-hour display is selected depending on the
setting of the FREQUENCY STEP switch on the
rear panel, so you cannot select a desired type
freely.
In the event of a power failure or when the AC
supply lead is disconnected.
The time display will go out, however, the clock will
function for about 5 minutes without power supply. So
you do not have to reset the time if the AC power
supply is resumed within about 5 minutes.
When the AC power supply is resumed after more than
5 minutes pass without power supply, the time display
will flash on and off to indicate that the time must be
reset.
This adjustment can be made even though this system
is in the standby mode.
Control range
When the power is on: ±0 to –6 (Preset value: ±0)
In the standby mode: +3 to –3 (Preset value: ±0)