Connections - Yamaha AV-1 Owner's Manual

CONNECTIONS

For General model only
FREQUENCY STEP switch
Because the interstation frequency spacing differs in
different areas, set the FREQUENCY STEP switch
(located at the rear) according to the frequency
spacing in your area. Before setting this switch,
disconnect the AC supply lead of this unit from the AC
outlet.
FM:100/50
AM: 10 /9kHz
PAL NTSC
FREQUENCY
STEP
ANTENNA
MONITOR OUT
VIDEO
SIGNAL
FM
GND AM
75 UNBAL. TO SW-AV1
MARK
FM:100/50 AUTO
AM: 10 /9kHz
PAL NTSC
IN
SYSTEM AUDIO
FREQUENCY TV
CONNECTOR OUTPUT VIDEO 1
STEP MODE
Connecting the AC supply lead
General model only
VOLTAGE
SELECTOR
240V
To AC outlet
AUTO
TV
MODE
OUT IN OUT IN
VCR TAPE/MD
L
R
MARK
SYSTEM
CONNECTOR
INPUT
R L R C L
FROM TCD–AV1 FRONT REAR CENTER REAR
TV MODE switch
This system is designed for use with the NTSC and
PAL television formats. Set this switch to the position
for the format your monitor TV employs.
PAL: Outputs signals in the PAL format no matter
which format (PAL or NTSC) of video signal is
sent from an external video unit to this system.
Set to this position if your monitor TV employs
the PAL format.
Note: In this position, the On Screen Display
function of this system will not work unless a
video signal is input to this system.
AUTO: Outputs signals in the same format as the
video signal input to this system employs.
Set to this position if your monitor TV can be
switched in between the PAL and NTSC
formats automatically.
NTSC: Outputs signals in the NTSC format no matter
which format (PAL or NTSC) of video signal is
sent from an external video unit to this sytem.
Set to this position if your monitor TV employs
the NTSC format.
Note
Make sure to input a video signal which employs the
same format that your monitor TV employs, otherwise
a picture will not be played back normally.
• After completing all connections, plug the AC supply
lead into a convenient AC outlet.
• Unplug the AC supply lead from the AC outlet if this
system is not to be used for a long period of time.
VOLTAGE SELECTOR (General model only)
The voltage selector on bottom of the power
amplifier/subwoofer (SW-AV1) must be set for
your local main voltage BEFORE plugging into
the AC main supply.
Voltages are 110/120/220/240V AC, 50/60 Hz.
E-17