Panasonic ES‑ST6N Manual page 45

Problem
The shaving sensor
responds even though
the shaver is not in
contact with the skin.
Foam cannot be
made in shaving foam
mode. ES‑ST6N
Foam made in
shaving foam mode
contains shavings.
ES‑ST6N
ES-ST6N_2N_CH.indb 45
Action
Clean the beard trimmings
from the shaver.
When the shaver is extremely
dirty, remove the foil frame
and wash with water.
(See page 41.)
Replace the system outer
foil and/or inner blades.
Expected life of system
outer foil and inner blades:
System outer foil:
Approximately 1 year
Inner blades:
Approximately 2 years
Making foam may be difficult
depending on the type of
facial cleansers etc., so
adjust the amount of water
or facial cleanser.
Before making foam, cleanly
rinse off any shavings.
(See page 41.)
Problem
The recommended
temperature for charging is
10 °C – 35 °C. If charged at
The shaver cannot be a temperature other than
charged. the recommended
temperature, the shaver
may take longer to charge
or may not charge at all.
Although the shaver can be
used for about 2 weeks after a
full charge (assuming dry‑
shave use for 3 minutes per
day), the usable number of
days might be lower depending
Operating time is
on how or where the shaver is
short even after a full
used (for example, when used
charge.
for wet shaving).
Apply oil.
When the number of
operations per charge starts
to decrease, the battery is
nearing the end of its life.
Action
45
2016/05/18 17:17:11