Using The Shaver - Panasonic ES‑ST6N Manual

4
4
Press the blades gently in the
palm of your hand, mix the facial
cleanser etc. around and move the
blades up and down to make
foam.
• If there is insuffi cient foam, add
slightly more water, hot water or facial cleanser
etc. to make it easier to create foam.
►Notes
• Before making foam, check that the blades are not
broken or deformed, and that the cleaning shutter is
closed.
• Do not use shaving agent (excluding foam), facial
cleansing foam (with scrubbing compounds) or soap
as these may cause the blades to clog, or be unable
to make foam.

Using the shaver

1
1
Press and shave.
• The power cannot be turned on
when the switch lock lamp ( )
blinks, as the power switch is
locked.
Press the power switch for more
than 2 seconds to unlock.
(See page 40.)
38
ES-ST6N_2N_CH.indb 38
Tips for better shaving
Apply the whole system outer foil
perpendicularly against the skin
and shave by slowly gliding the
shaver over the face against the
grain of the beard.
• The beard under the chin and
around the throat can be shaved
better by stretching the skin so
the beard will stand.
• To prevent damaging the system
outer foil, do not shave with only
a part of the system outer foil.
You can also use a pen grip to
hold the shaver.
2
2
Press when fi nished.
When the battery capacity is low
The charge status lamp ( ) blinks once
every second when operating the shaver.
• You can shave 2 to 3 times after the
charge status lamp ( ) blinks. (This
will differ depending on usage.)
2016/05/18 17:17:08