O) Programming The Door Opener Button - Renkforce 1582597 Operating Instructions Manual

o) Programming the door opener button

The following section describes the various setting modes and how to configure them.
85 + [Open delay, option 0 to 4] + # = Configure the button behaviour
To configure the circuit for the door opener button, proceed as follows:
3 2 8 9
*
8 5
0
#
or
8 5
1
#
or
8 5
2
#
or
8 5
3
#
or
Enter the master code (in this example, the master code is "3289")
to enable programming mode, and then press the * key. The code lock
will beep twice and the yellow LED will stay constant to indicate that
programming mode is enabled.
Enter the memory code "85". "0" enables the default setting for the door
opener button. With this setting, the relay is activated immediately without
a notification tone when the button is pressed.
Press the # key to confirm your entry.
Enter the memory code "85". Press "1". With this setting, the relay is
activated 5 seconds after the button is pressed. The code lock plays
notification tones during this time, which stop when the door is opened.
Press the # key to confirm your entry.
Enter the memory code "85". Press "2". With this setting, the relay is
activated 10 seconds after the button is pressed. The code lock plays
notification tones during this time, which stop when the door is opened.
Press the # key to confirm your entry.
Enter the memory code "85".
Press "3". With this setting, the relay is activated when the button is
pressed for 5 seconds. The code lock plays notification tones during this
time, which stop when the button is released.
Press the # key to confirm your entry.
69