Range Hood Care; Cleaning - Whirlpool WVW91330KS Installation Instructions And Use & Care Manual

Blower maximum speed button (D)
Press button (D) to turn the blower on to the maximum speed.
The LED will turn ON .
Press button (D) again to turn the blower maximum speed off.
The LED will turn off.
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water, or all purpose cleanser.
■
Wipe with a damp soft cloth or nonabrasive sponge, and
■
then rinse with clean water and wipe dry.
Metal Grease Filter
1. Remove the filter by pulling the spring release handle, and
then pulling down the filter.
A
A. Spring release handle
2. Grease filters should be cleaned using warm water,
dishwashing liquid, and a non-abrasive brush. Dishwasher
not recommended.
3. Reinstall the filter by making sure the spring release handle is
toward the left. Insert aluminum filter into upper track.
4. Push in spring release handle.
5. Push up on metal filter and release handle to latch into place.
NOTE: If the blower is at maximum speed and button (D) is
pressed, the blower will turn to the next lower speed button with
the LED on (C medium speed or B minimum speed).

RANGE HOOD CARE

Cleaning

Non-Vented (recirculating) Charcoal Filters
The charcoal filter is not washable. Replace with Charcoal Filter
Kit. See the "Assistance or Service" section for information on
ordering.
NOTE: When used in recirculation mode, To Reduce the Risk of
Fire and Shock use only conversion kit Models:
■
■
Replacing an LED Lamp
The LED lights are replaceable by a service technician only.
See the "Assistance or Service" section for service contact
information.
Recirculation Kit W11446297
Charcoal Filter Kit W11446294
11