Table of Contents
Advertisement
mmWave OTA Test Visualizer
The mmWave OTA Test Visualizer completes offline analysis of your test data for antenna
measurements.
Load your measurement results into the mmWave OTA Test Visualizer to view your antenna
pattern in different visualizations and analyze your antenna-specific measurements.
The mmWave OTA Test Visualizer is located at Start»All Programs»National Instruments»
OTA Test»Visualizer.
1
2
3
1. Configuration Tab
2. Cut Analysis Tab
Refer to the following sections for more information about the configuration options in the
mmWave OTA Test Visualizer.
Related Information
File Format for Measurement Results
Configuration Tab
Use this tab to configure basic settings for the file to visualize.
Figure 5. mmWave OTA Test Visualizer
on page 32
mmWave OTA Validation Test Reference Architecture | © National Instruments | 27
3. Plot Settings Tab
4. Plot Plane Window
4
Advertisement
Table of Contents
