Software Reference; Soft Front Panels - National Instruments mmWave User Manual

Your system is fully operational if the sequence finishes without error and you can display a
3D antenna pattern from the antenna. To verify the accuracy of the test, refer to
System Calibration
Tip NI recommends familiarizing yourself with the example sequences. When you
save the example sequence as a new file, you must also save the CSV file with the
same file name so the sequence file can load it correctly.
Related Information
mmWave OTA Test Positioner SFP
mmWave OTA Test Visualizer

Software Reference

Soft Front Panels

mmWave OTA Test Positioner SFP
The mmWave OTA Test Positioner SFP allows you to quickly manipulate the positioner.
You can complete the following tasks with the mmWave OTA Test Positioner SFP:
• Move the azimuth or elevation independently
• Configure a sweep in both azimuth and elevation
• Configure the Absolute Zero location of the positioner for antenna alignment
You can access the mmWave OTA Test Positioner SFP at Start»All Programs»National
Instruments»OTA Test»Positioner»mmWave OTA Test Positioner SFP.
on page 18.
on page 25
on page 27
mmWave OTA Validation Test Reference Architecture | © National Instruments | 25
Performing