Verifying Hardware Connections - National Instruments mmWave User Manual

Opening the Chamber Door During Operation
It is important that the chamber door remain closed when you are performing a test. If the key
switch is set to Auto and you open the door during operation, all movement in the chamber
stops and you must press Reset to return the chamber to the default state. No action is required
if the key switch is set to Manual and you open and close the door during operation.
Related Information
mmWave OTA Validation Anechoic Chamber Exterior

Verifying Hardware Connections

Before you begin using the mmWave OTA Validation Anechoic Chamber, refer to the
following sections to verify the external and internal connections.
External Connections
Ensure that all required instrumentation is properly configured with the mmWave OTA
Validation Anechoic Chamber before use.
Note
• The following figure does not show the PXIe-5831 installed in the chassis or
the required connections between the PXIe-5831 and mmRH-5582. Refer to the
PXIe-5831 Getting Started Guide
PXIe-5831 and all mmRH-5582 modules are properly interconnected.
• Refer to the
ni.com/manuals for detailed installation instructions.
The following figure shows a properly configured mmWave OTA Validation Anechoic
Chamber connected to the required instrumentation.
PXIe-6361 and the
mmWave OTA Validation Test Reference Architecture | © National Instruments | 11
on page 4
at ni.com/manuals to verify that the
PXIe-1092 or PXIe-1095 documentation at