Trigger Sensor Adjustment; Distance Sensor Adjustment; Gear Alignment; Sensor Height Adustment - Graco A Series Instructions-Parts List Manual

Trigger Sensor Adjustment

Refer to Troubleshooting for trigger sensor adjustment,
and Manual 309413.

Distance Sensor Adjustment

Gear Alignment

5. Install wheel (82) on LineLazer. 6.Install nut (62) until
tight, then back off 1/4 turn.
1. Relieve pressure; page 7.
2. Fig. 7. Remove dust cap (74) from wheel. Remove
nut (62).
,QVLGH RI WLUH
F . 7
IG
309414N
3. Remove wheel (82) from LineLazer.
4. Align gear (57) with sensor.
a. Pull gear out from wheel with gear puller.
b. Push gear in toward wheel with mallet. Torque
to 8 +/ 2 in-lb.
5. Install wheel (82) on LineLazer.
6. Install nut (62) until tight, then back off 1/4 turn.
Install dust cap (74) on wheel.

Sensor Height Adustment

1. Remove wheel (82) from LineLazer.
2. Remove sensor assembly (58).
3. Adjust sensor assembly height with two 17 mm nuts
of sensor so bottom surface of sensor is 0.638 +/
0.020 from bottom surface of shield.
Torque to 8+/- 2 in-lb.
)UDPH
$[\O
Trigger Sensor Adjustment
'LVWDQFH
6HQVRU
7LUH

*HDU
ti1955a
17