On/Off Switch; Removal; Installation - Graco A Series Instructions-Parts List Manual

On/Off Switch

On/Off Switch

Removal

1. Relieve pressure; page 7.
2. Fig. 6. Remove four screws (93) and display/cover
(139).
3. Pull display connector wings (A) open on PC board
and pull display connector out.
4. Disconnect ON/OFF switch connector (B) from PC
board.
5. Press in on two retaining tabs on each side of
ON/OFF switch (24) and remove switch.
169
Z
Y
F . 6
IG
16
139
93
214
24
B
%DFN 9LHZ 

Installation

1. Install new ON/OFF switch (24) so tabs of switch
snap into place on inside of pressure control hous-
ing.
2. Connect ON/OFF switch connector (B) to PC board.
3. Push display connector into PC board close
dis¬play connector wings (A) on PC board.
4. Install display/cover (139) with four screws (93).
108
F
214
109
D
E
WL D
309414N