Settings For All Parts - Yamaha CP5 Reference Manual

Settings for All Parts

Reverb Block
This section describes the parameters used to configure the reverb effect that is applied to all of the
parts from each of your stage piano's Performances. Settings for these parameters are made via
the Reverb screen, which contains two pages.
Press and hold the [REVERB] button (for at least one second)
Edit Sequence
required page using the [
On-screen name
Page
(and full name)
1
RevType
(Reverb Type)
2 RevTime
(Reverb Time)
HPF (High-pass
Filter Cutoff)
FBHiDamp
(Feedback High
Damping)
42 CP5/CP50 Reference Manual
PAGE] and [PAGE
L
This parameter is used to select the type of reverb to be applied.
Setting values: RichHall, RichPlt, RichRoom, WoodRoom, Room1, Room2,
Stage1, or Stage2
RichHall (Rich Hall) Emulation of hall acoustics with a rich, deep reverb sound.
RichPlt (Rich Plate) Emulation of a rich, sustained plate reverb sound.
RichRoom Emulation of room acoustics with a gentle reverb sound.
(Rich Room)
WoodRoom Emulation of room acoustics with a warm reverb sound.
(Woody Room)
Room1 Emulation of room acoustics with a crisp reverb sound.
Room2 Emulation of room acoustics with a deeper reverb sound.
Stage1 Emulation of stage acoustics with a wide, sustained reverb
sound.
Stage2 Emulation of the reverb typical of a smaller stage.
This parameter is used to set how long it takes in seconds for the reverb sound to
fade to silence.
Setting values: WoodRoom ......................0.3s to 10.0s
Other reverb types...........0.3s to 30.0s
This parameter is used to set the cutoff frequency for the Reverb block's high-pass
filter.
Setting values: 20Hz to 8.0kHz
This parameter is used to adjust the brightness' of the reverb sound. At higher set-
tings, it takes longer for the high-frequency component to decay, producing a
brighter overall reverb sound. This parameter is not displayed on-screen when
RevType has been set to "WoodRoom".
Setting values: 0.1 to 1.0

Navigate to the
] buttons  Turn Knobs 1 to 3
R
Description
Internal Design of the CP5 & CP50
Reference
Left & Right Parts
R [VOICE]
R
[PRE-AMP]
R [MOD-FX]
R [PWR-AMP] (CP5 only)
R [LEFT1]/[LEFT2]/[RIGHT1]/
[RIGHT2] (CP5)
[LEFT]/[RIGHT] (CP50)
R [COMMON]
Song Setting Area
R
[SONG SETTING]
[RECORD]
R
TRACK Part
R [TRACK]
MIC INPUT Part
[MIC INPUT] (CP5 only)
R
Settings for All Parts
R [REVERB]
Settings for All Performances
[MASTER COMPRESSOR]
R
R [UTILITY]
R [FILE]
Appendix