Yamaha CP5 Reference Manual page 18

For non-piano voices:
Effect category
In the case of non-piano voices, effects can be selected from the categories that make up the Other
group as described above. In addition, the modulation effects, which are primarily for PIANO and
E.PIANO voices, are grouped together in the MOD category. For more details regarding these
effects, see For PIANO and E.PIANO voices (page 15). All effects for non-piano voices function as
insertion effects.
Configuring Modulation Effect Block Parameters
Press and hold the [MOD FX] button (for at least one second)
Edit Sequence
and subsequent pages using the [
Each Modulation Block effect is configured using a different set of parameters, which adjust the
sound of the effect in various ways. The following tables will describe the functions of each of these
parameters in alphabetic order, first for the modulation effects (specially designed for PIANO and
E.PIANO voices) and then for the effects from the Other group.
NOTE
For more details on the specific parameters associated with each different type of effect, see the Modulation Effect
parameter list in the Data List pdf document.
Parameters for modulation effects
On-screen name
(and full name)
B Bottom
C Color
D Delay
Depth
Drive
F Feedback
M Manual
Mix
Mode
P PdlCtrl
(Pedal Control)
Phase
18 CP5/CP50 Reference Manual
Ins1Type
MOD > SmallPha
Effect name
PAGE] and [PAGE
L
Associated effects
Touch Wah and Pedal Wah
Small Phaser
Symphonic
Flanger, Chorus, 816Chorus, and
Symphonic
Small Phaser and Max90
Touch Wah and Pedal Wah
Flanger and 816Chorus
Flanger
Flanger, Chorus, 816Chorus, and
Symphonic
Max100
Pedal Wah
816Chorus
E

Navigate to the second
] buttons  Turn Knobs 1 to 3
R
Description
This parameter is used to set the lowest point
in the filter's sweep range.
This parameter is used to adjust the way in
which the phaser sweeps.
This parameter is used to set an offset for the
modulation delay time.
This parameter is used to adjust the depth of
modulation.
This parameter is used to set the phaser's
input level.
This parameter is used to adjust the way in
which the sound distorts.
This parameter is used adjust the degree to
which output from the effect is fed back into
its input.
This parameter is used to set the offset value
for delay modulation.
This parameter is used to adjust the volume
of the wet sound (i.e., the sound produced by
the effect).
This parameter is used to select the phaser
mode.
This parameter is used to set the cutoff fre-
quency for the wah filter.
This parameter is used to set the phase offset
for the chorus effect.
Internal Design of the CP5 & CP50
Reference
Left & Right Parts
R [VOICE]
R
[PRE-AMP]
R [MOD-FX]
R [PWR-AMP] (CP5 only)
R [LEFT1]/[LEFT2]/[RIGHT1]/
[RIGHT2] (CP5)
[LEFT]/[RIGHT] (CP50)
R [COMMON]
Song Setting Area
R
[SONG SETTING]
[RECORD]
R
TRACK Part
R [TRACK]
MIC INPUT Part
[MIC INPUT] (CP5 only)
R
Settings for All Parts
R [REVERB]
Settings for All Performances
[MASTER COMPRESSOR]
R
R [UTILITY]
R [FILE]
Appendix