Yamaha CP5 Reference Manual page 41

On-screen name
Page
(and full name)
3 CompTh
(Compressor
Threshold)
4 CompRat
(Compression Ratio)
CompOut
(Compressor Output
Level)
5 L.Freq
(Low Frequency)
L.Gain (Low Gain)
6 M.Freq
(Mid Frequency)
M.Gain (Mid Gain)
M.Width (Mid Width)
7 H.Freq
(High Frequency)
H.Gain (High Gain)
Mic Insert Effect Screen
From the Mic Insert Effect screen, you can select and configure an insertion effect to process audio
signals input via the MIC INPUT jack. Depending on the effect selected, this screen can contain up
to six pages.
Press and hold the [MIC INPUT] button (for at least one second)
Edit Sequence using the [PAGE
page using the [
On-screen name
Page
(and full name)
1 MicInsType
(Mic Insert Effect
Type)
2 to 6 Effect parameters
41 CP5/CP50 Reference Manual
This parameter is used to set the input level at which the compressor starts com-
pressing the sound.
Setting values: -48dB to -6dB
This parameter is used to set the compression ratio.
Setting values: 1.0 to 20.0
This parameter is used to adjust the compressor's output level.
Setting values: 0 to 127
This parameter is used to set a low-band frequency for boosting or cutting of the
sound.
Setting values: 32Hz to 2.0kHz
This parameter is used to set the degree to which low-band frequencies will be
boosted or cut.
Setting values: -12dB to +12dB
This parameter is used to set a mid-band frequency around which the sound will
be boosted or cut.
Setting values: 100Hz to 10.0kHz
This parameter is used to set the degree to which mid-band frequencies will be
boosted or cut.
Setting values: -12dB to +12dB
This parameter is used to set the width of the mid-frequency EQ band.
Setting values: 0.1 to 12.0
This parameter is used to set a high-band frequency for boosting or cutting of the
sound.
Setting values: 500Hz to 16.0kHz
This parameter is used to set the degree to which high-band frequencies will be
boosted or cut.
Setting values: -12dB to +12dB
] button or [2] button 
R
PAGE] and [PAGE ] buttons
L R
This parameter is used to select a category and effect type for the MIC INPUT
part's audio signals. These categories and effects are identical to those from the
Modulation Effect block's Other group, and more details can be obtained from the
table on page 16.
The parameters presented on Page 2 onward will depend on the MicInsType set-
tings. For more details, see Parameters for non-piano voice effects (page 19).
Description

Navigate to Page 2
Press Knob 2  Navigate to the required

Turn Knobs 1 to 3
Description
Internal Design of the CP5 & CP50
Reference
Left & Right Parts
R [VOICE]
R
[PRE-AMP]
R [MOD-FX]
R [PWR-AMP] (CP5 only)
R [LEFT1]/[LEFT2]/[RIGHT1]/
[RIGHT2] (CP5)
[LEFT]/[RIGHT] (CP50)
R [COMMON]
Song Setting Area
R
[SONG SETTING]
[RECORD]
R
TRACK Part
R [TRACK]
MIC INPUT Part
[MIC INPUT] (CP5 only)
R
Settings for All Parts
R [REVERB]
Settings for All Performances
[MASTER COMPRESSOR]
R
R [UTILITY]
R [FILE]
Appendix