Yamaha CP5 Reference Manual page 26

For non-piano voices:
Effect category
In the case of non-piano voices, effects are selected from the categories that make up the Other
group as described above. In addition, the power amplifiers and the compressor designed for
PIANO and E.PIANO voices are grouped together in the PWR category. See For PIANO and
E.PIANO voices (page 25) for more details on these. All effects for non-piano voices function as
insertion effects.
Configuring Power-Amplifier / Compressor Block Parameters
Press and hold the [PWR-AMP] button (for at least one second)
Edit Sequence second and subsequent pages using the [
1 to 3
Each power-amplifier / compressor type is configured using a different set of parameters, which
adjust the sound produced by the block in various ways. All parameters for the power amplifiers
and the compressor specially designed for PIANO and E.PIANO voices are described in alphabetic
order in the following table. The effects from the Other group are identical to those from the Modula-
tion Effect block, and details on their parameters can be obtained from the table on page 19.
NOTE
For more details on the specific parameters associated with each different type of effect, see the Power-Amplifier /
Compressor parameter list in the Data List pdf document.
Power-Amplifier & Compressor Parameters
On-screen name
(and full name)
A Attack Compressor 376
D Drive Compressor 376
L LineBal PowerAmp 71Rd I/73Rd I/
(Line Balance) 75Rd I/78Rd II/69Wr/77Wr
O Output PowerAmp 71Rd I/73Rd I/
75Rd I/78Rd II/69Wr/77Wr,
Compressor 376, and Clean
Amp
R Ratio Compressor 376
Release Compressor 376
26 CP5/CP50 Reference Manual
Ins2Type
PWR > 71Rd I
Effect name
L
Associated effects
This parameter is used to set the amount of time
that elapses between arrival of an input signal and
activation of the compressor.
This parameter is used to adjust the degree to
which compression is applied.
This parameter is used to adjust the balance
between the speaker output (S) and line output (L).
This parameter is used to set the output level.
This parameter is used to set the compression
ratio.
This parameter is used to set the amount of time
over which the compressor stops compressing the
sound.
E

Navigate to the

PAGE] and [PAGE ] buttons
R
Description
Internal Design of the CP5 & CP50
Reference
Left & Right Parts
R [VOICE]
R
[PRE-AMP]
R [MOD-FX]
R [PWR-AMP] (CP5 only)
R [LEFT1]/[LEFT2]/[RIGHT1]/
[RIGHT2] (CP5)
[LEFT]/[RIGHT] (CP50)
R [COMMON]
Song Setting Area
R
[SONG SETTING]
[RECORD]
R
Turn Knobs
TRACK Part
R [TRACK]
MIC INPUT Part
[MIC INPUT] (CP5 only)
R
Settings for All Parts
R [REVERB]
Settings for All Performances
[MASTER COMPRESSOR]
R
R [UTILITY]
R [FILE]
Appendix