Before Installing; Prepare The Charger For Installation; Location; Positioning - Wallbox PULSAR PLUS Installation Manual

EN
GETTING STARTED
Before Installing Pulsar Plus
Before installing your charger, be sure to obtain any required permits and/or approvals in
accordance with applicable codes, regulations, and ordinances for electrical installations.
Plug-in Version
Cable length
Outlet Height
Recommended
43-59 "
(110-150cm)
8
Hardwire Version
12" (30cm)
Charger Height
Recommended
50-67 "
(130-170cm)
Prepare Charger for
Installation
Before getting started, carefully lift the charger
from the packaging, remove the cardboard
covering the cables, and carefully unfasten the
plastic cable ties on the EV cable bundle. Leave
the cables in the box until needed to ensure they
do not get damaged during installation.
Check the product label to identify the model/
version of your charger. Make note of the serial
number (SN) and unique identification number
(UID) as you will need these to complete the
registration of your charger.

Location

For the placement of your charger, consider
how you will normally park your car, the
location of the vehicle's charge port, and the
length of the charging cable (25 feet/750cm).
NOTE: You should always have enough
slack in the charging cable so as not to apply
tension to the cable or the cable connections.
For secure mounting, you will want to install
your charger on a vertical wall stud or on a
solid wall with appropriate mounting anchors.

Positioning

We recommend installing your charger as
shown in the diagram on the left. Note that the
minimum installation height must be at least
18" (46cm), measured from the bottom of your
charger. Wallbox recommends an installation
height of 50-67" (130-170cm).
With NEMA cable installations, be sure to take
into consideration the 12" (30cm) length of
NEMA cable when positioning your charger in
relation to the NEMA receptacle.
For hardwire installations, the wiring may use
either the rear or bottom access ports in your
charger. Be sure to note that the power supply
wiring and conduit (if used) will need to be
placed on the left side of your charger.
40A NEMA Plug-in installation: Page 9
40A or 48A Hardwire installation: Page 12