ABB Ability Naveo Pro GW 1.0 Operation Manual page 30

30 A B B A B I L I T Y ™ N AV E O ® P R O G AT E W AY
—
9 Power
To supply power and turn ON the Naveo®Pro Gateway, complete the following steps:
• Setup a DC power source that:
1. Check the input voltage as close as possible to the Power IN connector. This is to compensate for
any cable losses, caused by cable length and other cable characteristics
2. Make sure that the DC power source is turned OFF
3. Connect the DC power source terminals ("Power IN +" and "Power IN -") to Pins 1 and 2 of the Power
IN connector
ELECTRIC SHOCK HAZARD
Failure to supply power correctly or to follow all operating instructions correctly, may create an electric
shock hazard, which could result in personal injury or loss of life, and / or damage the equipment or
other property.
To avoid injuries and safely supply power to the product, complete the following steps:
1. Observe all the instructions for safety, installation, and operation
2. Make sure your hands are dry
3. Make sure that all the cables used:
• Are in good condition before using them
• Meet the product requirements and comply with the relevant standards and regulations
4. Position cables with care. Do not position cables in places where they may be trampled or
compressed by objects placed on them
5. Make sure that the power-points and plugs are in good condition before using them
6. Do not overload the power-points and plugs
7. Make sure that the product maintains a proper grounding connection
8. Use a power supply that meets the electrical requirements and complies with the relevant
standards and regulations.
9. Connect power after the installation of the system has been completed
- Meets the Naveo®Pro Gateway power requirements
WARNING