Operation; Loading A Disc; Ejecting A Disc - Yamaha CRW2100SX Series Owner's Manual

Operation

This section explains how to operate the CRW2100SX drive after you have
installed it. You can load and eject a disc (as described below) only when the
CRW2100SX is powered on.

Loading a Disc

1 Open the tray by pressing the Eject button on the CRW2100SX drive' s front
panel.
2 Place the disc onto the tray with its label or printing facing upward.
3 Press the Eject button to close the tray.
n Do not push or pull the tray using excessive force. Doing so can damage the drive
or the disc. Instead, always use the Eject button to open or close the tray.

Ejecting a Disc

1 Open the tray by pressing the Eject button on the CRW2100SX drive' s front
panel.
2 Remove the disc from the tray.
3 Press the Eject button to close the tray.
n It may not be possible to eject the disc tray while a disc is being read or in other
situations, depending on the SCSI command.
n Only remove the disc after the disc tray has opened fully. Otherwise, you risk
damaging the drive or the disc.
1
1
2
2
24