Verifying The Hardware Installation - Yamaha CRW2100SX Series Owner's Manual

Verifying the Hardware Installation

Windows Users
1 When the computer's operating system is loading, your SCSI card will be
recognized and you will be prompted to install the drivers for it. Follow the
on-screen instructions and choose to reboot your computer at the end of the
driver installation procedure.
n For details about installing the drivers for your SCSI card, refer to the
documentation that came with it. Also refer to the documentation that came with
your computer' s operating system.
2 After the computer' s operating system (Windows 95/98/98 Second Edition)
has loaded, open the "Control Panel" and double-click on the "System" icon.
Select the "Device Manager" tab and double-click on "CDROM." If the drive
has been correctly installed, it should be listed as shown below. Similarly,
double-click on "SCSI controllers" and the SCSI card should be listed as
shown below if it has been properly installed.
n For details about how to use the operating system, refer to the documentation that
came with it.
n If there is a
SCSI card, this means that it has not been installed correctly.
n When using Windows NT, you can verify by opening the "Control Panel," double-
clicking on "SCSI Adapter" and clicking the "Devices" tab.
n For Windows 2000, double-click "System" in the "Control Panel," select the
"Hardware" tab, and click the "Device Manager" button in "System Properties."
or mark etc. next to the icon for the CRW2100SX drive or the
* This is a screen shown in the Windows 98
Second Edition environment.
Setup Procedures
22