Table of Contents
Advertisement
User Guide
Installation
Run the file on the CD and follow the Installation Instructions.
Getting Started
After the power supply has been connected and switched on, it is possible to
configure the LMP using the configuration software. Connect the configurator
cable between the PC and the LMP and run the software by running the .exe
file in the installation directory. The configurator software should respond
with the display as shown below.
1
2
3
4
5
6
Note
This software is designed for use with Landmark Technic, but can be used
with the LMP when in this mode.
Configurator features key:
1)
Title bar indicating configuration file name
2)
A menu bar
3)
A 'live' display showing actual configuration and process data from
the connected processor
4)
A 'configuration area' allowing parameters to be adjusted
5)
Buttons for applying/reading the configuration to/from the processor
Configuration parameters can be stored to the LMP and/or can be downloaded
to a file on the PC for later use. It is possible to use the software without an
LMP, however, only file menus will be available.
Fig. B1 Configurator Display
Landmark for Profibus
Page 25
Advertisement
Table of Contents
