Table of Contents
Advertisement
IkaScope WS
Ultra portable oscilloscope
• Do not use the product if it operates incorrectly.
• Before use, inspect device casing, probes, test leads and accessories for mechanical damage
and replace if damaged.
• Never attempt to repair a defective device. Contact customer service.
• Do not use the product or its accessories in case of any damage.
• Disconnect all probes, test leads and accessories that are not in use.
• Never use the device for measuring mains circuits.
• Never use the device for measuring circuits which are not galvanically isolated from mains
circuits.
• Do not touch electrical wires with bare hands.
• Keep away from children's sight or from animals.
• Do not expose to water, heat or moisture.
• Do not point probe tip toward body parts.
• Do not connect the ground lead to voltages higher than ±
• The electrical isolation between the USB port and the measurement ports is NOT designed to
isolate from mains circuit.
• Do not apply more than the rated voltage (± V), between the terminals or between each terminal
and USB port ground.
• Do not apply input voltages above the rating of the instrument (±
• Measure a known voltage first to make sure that the product operates correctly.
• Do not work alone.
• Comply with local and national safety codes. Use personal protective equipment (approved
rubber gloves, face protection, and flame resistant clothes) to prevent shock.
• Do not operate the product with covers removed or the case open. Hazardous voltage exposure
is possible.
• Only recharge from a USB port.
• Do not use the device in wet or damp conditions, or around explosive gas or vapor.
• Do not use in a system in which the failure of the product might result in personal injury.
Lithium battery safety information
IkaScope WS
contains a
Warning To avoid electrical shock or fire:
• Never attempt to open an IkaScope WS
(c) Ikalogic SAS
mAh lithium battery.
.
V from earth ground.
V).
WS
Advertisement
Table of Contents
