Table of Contents
Advertisement
IkaScope WS200 Ultra portable oscilloscope
• Do not use the product if it operates incorrectly.
• Before use, inspect device casing, probes, test leads and accessories for mechanical damage
and replace if damaged.
• Never attempt to repair a defective device. Contact customer service.
• Do not use the product or its accessories in case of any damage.
• Disconnect all probes, test leads and accessories that are not in use.
• Never use the device for measuring mains circuits.
• Never use the device for measuring circuits which are not galvanically isolated from mains
circuits.
• Do not touch electrical wires with bare hands.
• Keep away from children's sight or from animals.
• Do not expose to water, heat or moisture.
• Do not point probe tip toward body parts.
• Do not connect the ground lead to voltages higher than ±40V from earth ground.
• The electrical isolation between the USB port and the measurement ports is NOT designed to
isolate from mains circuit.
• Do not apply more than the rated voltage (±40V), between the terminals or between each terminal
and USB port ground.
• Do not apply input voltages above the rating of the instrument (±40V).
• Measure a known voltage first to make sure that the product operates correctly.
• Do not work alone.
• Comply with local and national safety codes. Use personal protective equipment (approved
rubber gloves, face protection, and flame resistant clothes) to prevent shock.
• Do not operate the product with covers removed or the case open. Hazardous voltage exposure
is possible.
• Only recharge from a compliant USB port (5V
• Do not use the device in wet or damp conditions, or around explosive gas or vapor.
• Do not use in a system in which the failure of the product might result in personal injury.
Periodically check and install new so ware updates on www.ikalogic.com as they can improve the
safety of the product as well as its features.
Lithium battery safety information
IkaScope WS200 contains a 3.7V 420mAh lithium battery.
Warning To avoid electrical shock or fire:
(c) Ikalogic SAS 2019
0.1V, 500mA). Never exceed this voltage.
WS200
18/21
Advertisement
Table of Contents
